Magnetic drill, also known as magnetic drill, iron drill, magnetic drill, punch, steel drill, iron drill, magnetic drill, portable magnet drill, magnetic drill, electric drill, drill and attack machine. Pay attention to the following when using the magnetic drill:
Remember that you cannot use the rig continuously for more than 5 hours; if you use the rig for a long time (more than 5 hours), the magnetic base will overheat and ignite. Do not touch the magnetic base with your hand. When you stop working, immediately turn off the power to the magnetic base and pull out the power plug.
Remember not to continue for more than 30 minutes; continuously turning on the motor for more than 30 minutes will cause the motor to overheat and catch fire. When you stop working, turn off the power immediately and pull out the power plug.
It can only be used on the metal surface of the magnetizer; it cannot be used on metals such as aluminum, copper, stainless steel, alloys, etc. that do not absorb magnetism.
Precautions for drilling holes in the wall:
Can't stand under the machine, the machine will cause personal injury if it falls. Before working, pour out the cutting fluid in the cooling pot and switch to the manual cutting fluid infusion device.
The thickness of the drilling face shall not be less than 9mm;
Keep the magnetic surface; the magnetic surface is dirty and there is debris, the suction will decrease, and the work should be cleaned.
The magnetic seat cannot be placed on the surface of the hole; placing the magnetic seat on the surface of the hole reduces the magnetic force.
Use iron chains for safety; to prevent the machine from falling, use a chain to tie the machine to prevent falls and injuries.
To ensure that the working surface of the magnetic seat is a plane
Be careful with iron filings;
Do not touch the core;
Never use the power of the power welder to drive the unit;